Reference Guide

Severity Severity 3 (Informational)
No alerts are applicable for this message
VFL0013
Message The vFlash SD Card is in read-only mode.
Detailed
Description
The request could not be successfully completed, because the vFlash SD Card is in
read-only mode. Write operations cannot be performed on the card.
Recommended
Response Action
Change the access mode on the vFlash SD Card to read-write.
Category System Health (VFL = vFlash Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
VFL0014
Message The vFlash SD card is not initialized.
Detailed
Description
The vFlash SD card is not initialized. Either the card is not properly formatted or it
may not be supported.
Recommended
Response Action
Format the vFlash SD card by running the command "racadm vflashsd initialize".
Make sure that the card is supported by contacting your service provider for a list
of supported SD card types.
Category System Health (VFL = vFlash Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
VFL0015
Message vFlash media partition is of read-only type.
Detailed
Description
The request could not be successfully completed, because the vFlash SD Card
partition is in read-only mode. Write operations cannot be performed on the card
partition.
Recommended
Response Action
Change the partition access type to read-write by running the command racadm
set idrac.vFlashPartition.<index>.accesstype 1.
Category Configuration (VFL = vFlash Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
2227