Reference Guide

Recommended
Response Action
Do the following: 1) Make sure the iSCSI target system is online with the firewall
configured to allow TCP access. 2) Make sure the server network infrastructure is
configured to allow access to the iSCSI target. 3) Go to System Setup > Network
Settings > iSCSI Device Settings > Connection Settings page, make sure the iSCSI
initiator settings (iSCSI, DHCP, VLAN, initiator/target IP addresses) are configured
correctly. 4) Retry the operation.
Category Configuration (UEFI = UEFI Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
UEFI0276
Message Unable to perform iSCSI boot on connection arg1 because the initiator information
from DHCPv6 server cannot be obtained.
Arguments arg1 = number
Detailed
Description
Unable to perform iSCSI boot on the connection identified in the message because
the initiator information from DHCPv6 server cannot be obtained.
Recommended
Response Action
Do one of the following: 1) Check the configuration of DHCPv6 server. 2) Go to
System Setup > Network Settings > iSCSI Device Settings > Connection Settings
page, disable DHCP and configure the initiator information manually. Retry the
operation.
Category Configuration (UEFI = UEFI Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
UEFI0277
Message Unable to perform iSCSI boot on connection arg1 because the iSCSI target
configuration data obtained from DHCPv6 server is invalid.
Arguments arg1 = number
Detailed
Description
Unable to perform iSCSI boot on the connection number identified in the message
because the iSCSI target configuration data obtained from DHCPv6 server is
invalid.
Recommended
Response Action
Do one of the following: 1) Reconfigure the DHCPv6 server boot file URL option,
and note that server name must be specified. 2) Go to System Setup > Network
Settings > iSCSI Device Settings > Connection Settings page, disable Target Info via
DHCP and configure the parameters manually. Retry the operation.
Category Configuration (UEFI = UEFI Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
2125