Reference Guide

Detailed
Description
The TPM chip cannot be initialized because the TPM chip is not functioning.
Recommended
Response Action
Remove input power from the system, wait for 30 seconds, and re-apply input
power. Turn on the system.
Category System Health (UEFI = UEFI Event)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
UEFI0033
Message Default system BIOS settings are in use because NVRAM_CLR jumper is installed on
the system board.
Detailed
Description
The NVRAM_CLR jumper is installed to clear the BIOS configuration. After clearing
the BIOS configuration, remove the NVRAM_CLR jumper so that the system can
function normally and any non-default BIOS system setting changes can be
persistently saved.
Recommended
Response Action
To change the system BIOS settings and persistently save the settings, remove the
NVRAM_CLR jumper and then go to the System Setup to configure system settings.
Category Configuration (UEFI = UEFI Event)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
1996