Reference Guide

LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
UEFI0021
Message The Lifecycle Controller feature is disabled.
Detailed
Description
The Lifecycle Controller feature is disabled. The feature was disabled because of
one of the following conditions: 1) The feature was disabled manually using the F2
System Setup utility or through an iDRAC interface, 2) BIOS encountered an issue
starting the feature and automatically disabled it.
Recommended
Response Action
To enable the Lifecycle Controller (LC) feature using F2 System Setup, select the
iDRAC Settings > Lifecycle Controller and then select Enabled. If LC becomes
disabled automatically, update the Lifecycle Controller firmware or apply the
Lifecycle Controller Repair Package.
Category Configuration (UEFI = UEFI Event)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
UEFI0022
Message Unable to initialize Management Engine because the Management Engine is not
responding.
Detailed
Description
The Management Engine firmware cannot be initialized because the Management
Engine is not responding.
Recommended
Response Action
Remove input power from the system, wait for 30 seconds, and re-apply input
power. Turn on the system.
Category System Health (UEFI = UEFI Event)
Severity Severity 1 (Critical)
1990