Reference Guide

LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔
CMC
TMP0300
Message The Enhanced Cooling Mode feature is enabled.
Detailed
Description
The Enhanced Cooling Mode feature is enabled.
Recommended
Response Action
No response action is required.
Category System Health (TMP = Temperature)
Severity Severity 3 (Informational)
No alerts are applicable for this message
TMP0301
Message The Enhanced Cooling Mode feature is disabled.
Detailed
Description
The Enhanced Cooling Mode feature is disabled.
Recommended
Response Action
No response action is required.
Category System Health (TMP = Temperature)
Severity Severity 3 (Informational)
No alerts are applicable for this message
TMP0302
Message Unable to set Enhanced Cooling Mode because the required power or fan
configuration is not available.
Detailed
Description
The Enhanced Cooling Mode feature cannot be enabled because the necessary
power or fan configuration is not available.
Recommended
Response Action
Do the following: 1) Check the available power and the fan configuration. 2) If the
required power for Enhanced Cooling mode is not available, remove other chassis
components which are not being used in order to obtain sufficient power. 3) If the
fan configuration does not support Enhanced Cooling Mode, replace unsupported
fans with supported ones. 4) If the issue persists, contact your service provider.
Category System Health (TMP = Temperature)
1962