Reference Guide

LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔* ✔*
SWC8618
Message Server Profiles: request arg1 for server in slot arg2 was unsuccessful. Message ID
arg3 . Returned fault: arg4 .
Arguments arg1 = wsman method, arg2 = slot number, arg3 = message id, arg4 = wsman fault
Detailed
Description
The request for the WS-Man method identified in the message for server in slot
identified slot is unsuccessful.
Recommended
Response Action
Make sure that iDRAC is ready and system is functioning correctly. run the
RACADM command at the command line interface (CLI), "racadm getversion" to list
all the servers and make sure that the iDRAC version is displayed. If the iDRAC is
listed as Not Ready then wait until it becomes ready. A Virtual Reseat may be
required.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC ✔
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔* ✔*
SWC8619
Message The Chassis Management Controller is unable to process data from the server in
slot arg1 .
Arguments arg1 = slot id
Detailed
Description
The Chassis Management Controller (CMC) is unable to process inventory data
from the server in the slot identified in the message. This can happen if: 1) There is
a communications issue between the CMC and the iDRAC on the server identified
in the message. 2) Incorrect firmware is installed on network cards. 3) Incorrect
firmware is installed on the server iDRAC. 4) There is no free temporary storage in
the CMC.
1814