Reference Guide

SWC8609
Message Server Profiles: unknown response received from server: arg1 for operation [ arg2 ]
because of one or more of the following reasons: 1) iDRAC is not ready. 2)
Lifecycle Controller of the server is disabled.
Arguments arg1 = slot number, arg2 = wsman_operation
Detailed
Description
The CMC was unable to perform the operation described in the message because
of one or more of the following reasons: 1) iDRAC is not ready. 2) Lifecycle
Controller of the server is disabled.
Recommended
Response Action
Make sure that iDRAC on the server identified in the message is operating and that
Lifecycle Controller is enabled, and then retry the operation. If the issue persists,
perform a virtual reseat of the server and retry the operation. To perform a virtual
reseat of the server, on CMC Web interface, select Chassis Overview ->
Troubleshooting -> Reset Components. On the Reset Components page, select
Virtual Reseat from the drop-down menu for the server identified in the message.
Category Configuration (SWC = Software Config)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC ✔
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔* ✔*
SWC8610
Message Job ID: arg1 . CMC sent all settings of profile arg2 to Server (Service Tag: arg3 ) in
Slot arg4 .
Arguments arg1 = job ID, arg2 = profile name, arg3 = service tag, arg4 = slot number
Detailed
Description
All settings of the selected profile were sent to the server identified in the message
and the operation is captured in the job identified in the message.
Recommended
Response Action
No response action is required.
Category Configuration (SWC = Software Config)
Severity Severity 3 (Informational)
1809