Reference Guide

SWC8500
Message Unable to generate Profile with [ arg1 ] settings.
Arguments arg1 = number of entries
Detailed
Description
Unable to communicate with iDRAC.
Recommended
Response Action
Check if iDRAC is ready and system is running properly. Utilize the RACADM
command by running "racadm getversion" to list all the servers and make sure the
iDRAC version is displayed. If the iDRAC is listed as Not Ready then wait until it
becomes ready. A Virtual Reseat may be required.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔* ✔*
SWC8501
Message Unable to generate Profile.
Detailed
Description
Unable to communicate with iDRAC.
Recommended
Response Action
Check if iDRAC is ready and system is running properly. Utilize the RACADM
command by running "racadm getversion" to list all the servers and make sure the
iDRAC version is displayed. If the iDRAC is listed as Not Ready then wait until it
becomes ready. A Virtual Reseat may be required.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
1780