Reference Guide

Detailed
Description
The Trap needs to be set for the particular index for the testtrap to go through.
Recommended
Response Action
Set cfgIpmiPetAlertEnable in cfgIpmiPet group using config subcommand for the
corresponding index.
Category Configuration (SWC = Software Config)
Severity Severity 3 (Informational)
No alerts are applicable for this message
SWC0131
Message Trap destination address must be configured.
Detailed
Description
The destination Ip address must be configured for the Trap.
Recommended
Response Action
Set cfgIpmiPetAlertDestIpAddr in cfgIpmiPet group using config subcommand for
the corresponding index.
Category Configuration (SWC = Software Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
SWC0132
Message Unable to send test trap. Please make sure that your trap has been configured
correctly and connectivity to the destination endpoint exists.
Detailed
Description
Either the destination Ip address is not reachable or the required values are not
configured.
Recommended
Response Action
Check for the connectivity to the configured Ip address.
Category Configuration (SWC = Software Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
SWC0133
Message Either connect or disconnect must be specified.
Detailed
Description
Insufficient information provided.
Recommended
Response Action
Specify either the connect or the disconnect option with the subcommand.
1710