Reference Guide

RED085
Message Unable to update the Chassis firmware, communication with Chassis Management
Controller took more time than expected.
Detailed
Description
The Chassis firmware cannot be updated because communication between iDRAC
and CMC took more time than expected.
Recommended
Response Action
Verify the status of CMC by accessing the CMC and making sure it is functioning
and responding and then retry the operation. For more information about
troubleshooting a CMC issue, see the CMC User Manual. If the issue persists,
contact your service provider.
Category Updates (RED = FW Download)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RED086
Message Unable to update the Chassis firmware, Chassis Management at Server is not set to
Monitor and Configure.
Detailed
Description
The Chassis firmware cannot be updated because the Chassis Management at
Server (CMAS) attribute is incorrectly set. The CMAS attribute must be set to
Monitor and Configure on the CMC in order to update CMC firmware from and
iDRAC.
Recommended
Response Action
Make sure that the Chassis Management at Server attribute is set to Monitor and
Configure, and then retry the operation. To set the correct attribute using Chassis
Management Controller (CMC) GUI, navigate to Chassis Overview, then Setup, then
General, and then click on the Chassis management at Server attribute to select the
correct value.
Category Updates (RED = FW Download)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RED087
Message Unable to update the Chassis firmware, Allow CMC Updates Through OS and
Lifecycle Controller is set to Disabled.
Detailed
Description
Unable to update the Chassis firmware because the Allow CMC Updates Through
OS and Lifecycle Controller setting is set to Disabled.
Recommended
Response Action
Make sure that the Allow CHC Updates Through OS and Lifecycle Controller
setting is set to Enabled, and then retry the operation. Using the iDRAC Web UI,
1468