Reference Guide

RAC1135
Message Unable to run the RACADM command because an internal instrumentation
component has stopped functioning.
Detailed
Description
The RACADM command could not be run because the internal instrumentation
components are either busy or have stopped functioning.
Recommended
Response Action
Wait for a minute for the internal instrumentation component to respond, and then
retry the operation. If the issue persists, reset the iDRAC by pressing the System ID
button for 15 seconds, wait for the iDRAC to finish restarting, and then retry the
operation. If the issue continues to persist, contact your service provider.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC
RAC1136
Message Remote unattended diagnostic execution operation initiated.
Detailed
Description
The remote unattended diagnostic execution operation is initiated.
Recommended
Response Action
Using the RACADM command line interface, run the "racadm jobqueue view -i <job
id>" command to view the status of the operation.
Category Configuration (RAC = RAC Event)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔
CMC
1336