Reference Guide

Detailed
Description
The command is unable to clear the pending state for attributes of the specified
component because there are no pending values.
Recommended
Response Action
Make sure that there is at least one attribute on the specified device has a pending
value, and retry the operation.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC1036
Message Successfully cleared pending attribute(s) for the group specified.
Detailed
Description
Successfully cleared pending values for attributes in the group specified.
Recommended
Response Action
To verify, run the RACADM command "racadm get group".
Category Configuration (RAC = RAC Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
RAC1037
Message Unable to clear pending attribute(s).
Detailed
Description
Unable to clear pending attribute(s). This may be because the FQDD entered is
incorrect.
Recommended
Response Action
Check that the FQDD entered is correct. View the Help information by running the
RACADM command "racadm help clearpending".
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC
1305