Reference Guide

Detailed
Description
The iDRAC Service Module is not installed on the operating system of the server.
Recommended
Response Action
Install the iDRAC Service Module and retry the operation.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC0692
Message Unable to assign and un-assign physical disk drives as global hotspare(s), because
Lifecycle Controller is not enabled.
Detailed
Description
Unable to assign and un-assign physical disk drives as global hotspare(s), because
Lifecycle Controller is not enabled.
Recommended
Response Action
To enable Lifecycle Controller, reboot the server. During server startup, press F2 to
enter System Setup. Go to iDRAC Settings -> Lifecycle Controller, select Enable,
and save the changes. Retry the operation after the server has restarted.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC0693
Message Pending operations are created for the selected operations on the selected
physical disk drives.
Detailed
Description
Pending operations are created for the selected operations on the selected
physical disk drives.
Recommended
Response Action
To view the pending operations, click the Pending Operations button.
Category Configuration (RAC = RAC Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
RAC0694
Message Unable to configure the attributes of the selected controller, because Lifecycle
Controller is not enabled.
Detailed
Description
Unable to configure the attributes of the selected controller, because Lifecycle
Controller is not enabled.
1254