Reference Guide

Detailed
Description
The power supply unit is not receiving input AC power. The power cable may not
be connected properly or removed. This can happen if there is an AC failure or
problems with the power strip attached to the enclosure power supply.
Recommended
Response Action
Reconnect the power cable to the power supply unit if it was disconnected.
Restore the input AC power supply. Make sure the power supply is restored to the
enclosure from the mains.
Category Storage (PSU = Power Supply)
Severity Severity 2 (Warning)
Trap/EventID 4234
OMSA Event ID 2312;2313
OMSA Trap ID 100300
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔ ✔ ✔ ✔
CMC ✔ ✔* ✔ ✔*
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔
CMC ✔ ✔* ✔*
PSU1001
Message arg1 has failed.
Arguments arg1 = PSU Sensor Name
Detailed
Description
The enclosure detected that a power supply unit has failed.
Recommended
Response Action
Check for other messages related to the state of the power supply unit/enclosure.
These may help determine the cause of this event. Contact technical support if the
issue still persists.
Category Storage (PSU = Power Supply)
Severity Severity 1 (Critical)
Trap/EventID 4233
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔ ✔ ✔ ✔
CMC ✔ ✔* ✔ ✔*
1071