Reference Guide

NIC010
Message Lifecycle Controller is not enabled, cannot create Configuration job.
Detailed
Description
For 11G systems: System Services must be enabled to perform the requested
operation. System Services has been disabled through the iDRAC configuration
utility accessed by pressing CTRL+E on boot up or through a remote operation. For
12G systems: Lifecycle Controller must be enabled to perform the requested
operation. Lifecycle Controller has been disabled by pressing F2 Setup, selecting
iDRAC Configuration, and selecting Lifecycle Controller Settings on boot up or
through a remote operation.
Recommended
Response
Action
For 11G systems: Use the iDRAC configuration utility to enable the System Services
by pressing on the CTRL+E option on boot up at the targeted system. For 12G
systems: Use F2 Setup, select iDRAC Configuration, and select Lifecycle Controller
Settings, to enable the Lifecycle Controller on boot up of the targeted system.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
NIC011
Message Configuration job already created, pending data cannot be deleted
Detailed
Description
Configuration job already created on the specified target. No further command is
allowed until the existing job is completed.
Recommended
Response
Action
Cancel the configuration job or wait for the job to complete. Refer to
documentation on job cancellation.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
NIC012
Message No pending data to delete.
Detailed
Description
No changes to BIOS attribute data are available between the previous configuration
and the current configuration.
Recommended
Response
Action
No response action is required.
Category Configuration (NIC = NIC Config)
822