Reference Guide

NIC004
Message Invalid parameter value for arg1
Arguments arg1 = attribute name
Detailed
Description
The value for the specified parameter is invalid.
Recommended
Response
Action
Verify that parameter values passed to the method are entered as they appear in
the enumeration and parameter data type matches the documentation.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
NIC005
Message Mismatch in AttributeName and AttributeValue count
Detailed
Description
The number of AttributeName and AttributeValue parameters do not match.
Recommended
Response
Action
Pass the same number of parameters for AttributeName and AttributeValue. Refer
to documentation for method input parameter details.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
NIC006
Message A configuration job already exists, Cannot set attribute on specified target until
existing job is completed or is cancelled
Detailed
Description
A configuration job already exists for the specified target. No further configuration
operation is allowed until the existing job completes or the job is cancelled.
Recommended
Response
Action
Do one of the following: 1) Wait for the existing configuration job to complete and
retry the operation, 2) To continue with a configuration change, cancel the existing
job and retry the operation.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
820