Reference Guide

Detailed
Description
The job ID specified as input to the operation has configuration data that is
currently being processed by the iDRAC. The job can be deleted after the
processing is done.
Recommended
Response
Action
Retry the operation. If the issue persists, reset the iDRAC by pressing the System ID
button for 15 seconds, wait for the iDRAC to finish restarting, and then retry the
operation.
Category Configuration (JCP = Job Control)
Severity Severity 3 (Informational)
No alerts are applicable for this message
JCP032
Message Unable to create a job because conflicting options are entered.
Detailed
Description
The configuration job cannot be created because the -r and --realtime options
cannot be used at the same time.
Recommended
Response
Action
Make sure that only one of either -r or --realtime option is entered. For example, to
run a job immediately, enter the --realtime option. To schedule a job that will be
run after restarting a server, use the -r option. For more information about options,
see the RACADM Command Line Reference Guide available at the support site. If
the issue persists, contact your service provider.
Category Configuration (JCP = Job Control)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC
JCP8501
Message Job ID: arg1 . CMC sent arg2 properties from arg3 profile to the server (Service Tag:
arg4 ) in the slot arg5 .
Arguments arg1 = job ID, arg2 = number of settings, arg3 = profile name, arg4 = service tag,
arg5 = slot number
Detailed
Description
This job information message occurs if some configuration stored in the profile are
not applicable to the target server.
705