Reference Guide

Recommended
Response
Action
No response action is required.
Category Audit (ISM = iDRAC Service Module)
Severity Severity 3 (Informational)
No alerts are applicable for this message
ISM0006
Message The iDRAC Service Module is unable to communicate with iDRAC using the OS to
iDRAC Pass-through channel.
Detailed
Description
The iDRAC Service Module could not successfully communicate with iDRAC,
because the OS to iDRAC Pass-through channel is not configured in the USB-NIC
mode.
Recommended
Response
Action
Make sure that the OS to iDRAC Pass-through channel is configured only in the
USB-NIC mode, and then retry the operation. To enable the OS-to-iDRAC Pass-
through channel, run the following command in the order they are listed: 1)
racadm set idrac.os-bmc.PTMode usb-p2p 2) racadm set idrac.os-
bmc.UsbNicIpAddress <ip address> 3) racadm set idrac.os-bmc.adminstate
enabled
Category Audit (ISM = iDRAC Service Module)
Severity Severity 1 (Critical)
No alerts are applicable for this message
ISM0007
Message The iDRAC Service Module communication with iDRAC has ended.
Detailed
Description
The iDRAC Service Module ended communication with iDRAC over the OS to
iDRAC Pass-through channel. This is because either iDRAC is being restarted or the
OS to iDRAC Pass-through configuration is being changed. The iDRAC Service
Module will continue to try connecting to iDRAC.
Recommended
Response
Action
No response action is required.
Category Audit (ISM = iDRAC Service Module)
Severity Severity 2 (Warning)
No alerts are applicable for this message
686