Reference Guide

Severity Severity 3 (Informational)
Trap/EventID 8595
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔ ✔ ✔ ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔
CMC
FSD002
Message Debug authorization failed; for debugCaps: arg1 , authorized by iDRAC user: arg2 ,
and Dell employee: arg3 , at arg4 for the period: arg5 to arg6 .
Arguments arg1 = DebugCaps, arg2 = IDRAC user, arg3 = Dell employee, arg4 = unblock time,
arg5 = start time, arg6 = end time
Detailed
Description
A RACADM Debug command failed. If the RACADM Debug command was
executed under the direction of Dell tech support then further assistance from tech
support should be requested. Otherwise this command is not intended for
customer use.
Recommended
Response
Action
Verify all of the following 1) ensure that the unblock, grant, and invoke/start/stop/
resume commands are all executed against the same iDRAC. 2) ensure dat.ini file
has not been changed in any way. 3) ensure that current date falls between the
start and end times. Note that Dell can further restrict both the set of debugCaps
that is authorized and the start and stop times. If an authorized person did not
enter a RACADM debug command then an attacker may have entered the
command.
Category Audit (FSD = Debug)
Severity Severity 2 (Warning)
Trap/EventID 8594
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔ ✔ ✔ ✔ ✔
CMC
568