Reference Guide

Recommended
Response
Action
Check for problems with the cables. See the Cables attached correctly section for
more information on checking the cables. You should also check to see if the
enclosure has degraded or failed components. To do this, select the enclosure
object in the tree view and click the Health subtab. The Health subtab displays the
status of the enclosure components. Verify that the controller has the supported
driver and firmware versions installed and that each Enclosure Management
Modules (EMMs) are running the same version of supported firmware.
Category Storage (ENC = Storage Enclosr)
Severity Severity 2 (Warning)
Trap/EventID 4338
OMSA Event ID 2137
OMSA Trap ID 85300
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC ✔ ✔* ✔ ✔*
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔ ✔* ✔
ENC7
Message The arg1 alarm was enabled.
Arguments arg1 = Enclosure Name
Detailed
Description
You have enabled the enclosure alarm. This alert is provided for informational
purposes.
Recommended
Response
Action
No response action is required.
Category Storage (ENC = Storage Enclosr)
Severity Severity 3 (Informational)
Trap/EventID 4339
OMSA Event ID 2138
OMSA Trap ID 85100
502