Reference Guide

Recommended
Response
Action
Category Storage (DIAG = Diagnostic)
Severity Severity 1 (Critical)
No alerts are applicable for this message
DIAG0149
Message Optical Drive - no drive detected.
Detailed
Description
Recommended
Response
Action
Category Storage (DIAG = Diagnostic)
Severity Severity 3 (Informational)
No alerts are applicable for this message
DIAG0150
Message Hard Drive - No Hard Drive detected, or disk controller not supported.
Detailed
Description
Recommended
Response
Action
Hard drives on desktops should be found if connected to the chipset disk
controller but PERC/SCU/SAS Adapters are not supported by legacy ePSA so if the
hard drive is connected to these controllers this message is just a warning. If the
system has a hard disk connected to the System Board chipset disk controller,
power down the system and check the signal and power connections to it. Rerun
the diagnostic.If no error occurs then it was a cable or connector issue.
Category Storage (DIAG = Diagnostic)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
428