Reference Guide

DIAG0144
Message Hard Drive arg1 - self test not supported.
Arguments arg1 = Drive Location
Detailed
Description
Mainly seen with very old hard drives
Recommended
Response
Action
Category Storage (DIAG = Diagnostic)
Severity Severity 2 (Warning)
No alerts are applicable for this message
DIAG0145
Message Hard Drive arg1 - S/N arg2 , self test did not complete.
Arguments arg1 = Drive Location, arg2 = Serial Number
Detailed
Description
Recommended
Response
Action
Desktops and Servers: Power down the system and check the signal and power
connections to the hard drive. Rerun the diagnostic.If no error occurs then it was a
cable or connector issue.
Category Storage (DIAG = Diagnostic)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔
CMC
DIAG0146
Message Hard Drive arg1 - S/N arg2 , self test log contains previous error(s).
Arguments arg1 = Drive Location, arg2 = Serial Number
426