Reference Guide

DIAG0142
Message Hard Drive arg1 - S/N arg2 , arg3 self test unsuccessful arg4 .
Arguments arg1 = Drive Location, arg2 = Serial Number, arg3 = DST Short, DST Long, arg4 =
Error Reason
Detailed
Description
Recommended
Response
Action
If <Error Reason> is "terminated" then the disk controller terminated the test so a
retry of the test is advisable.Otherwise the hard drive should be replaced. {In the
factory, this test type may also be DEFT, in addition to DST Short and DST Long.
The "terminated" case should not occur in the field, only in development due to
software issues}
Category Storage (DIAG = Diagnostic)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔
CMC
DIAG0143
Message Hard Drive arg1 - SMART read command unsuccessful.
Arguments arg1 = Drive Location
Detailed
Description
Mainly seen with very old hard drives
Recommended
Response
Action
Category Storage (DIAG = Diagnostic)
Severity Severity 1 (Critical)
No alerts are applicable for this message
425