Reference Guide

Detailed
Description
For 11G systems: System Services must be enabled to perform the requested
operation. System Services has been disabled through the iDRAC configuration
utility accessed by pressing CTRL+E on boot up or through a remote operation. For
12G systems: Lifecycle Controller must be enabled to perform the requested
operation. Lifecycle Controller has been disabled by pressing F2 Setup, selecting
iDRAC Configuration, and selecting Lifecycle Controller Settings on boot up or
through a remote operation.
Recommended
Response
Action
For 11G systems: Use the iDRAC configuration utility to enable the System Services
by pressing on the CTRL+E option on boot up at the targeted system. For 12G
systems: Use F2 Setup, select iDRAC Configuration, and select Lifecycle Controller
Settings, to enable the Lifecycle Controller on boot up of the targeted system.
Category Configuration (BIOS = BIOS Management)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
BIOS011
Message Configuration job already created, pending data cannot be deleted
Detailed
Description
Configuration job already created on the specified target. No further command is
allowed until the existing job is completed.
Recommended
Response
Action
Cancel the configuration job or wait for the job to complete. Refer to
documentation on job cancellation.
Category Configuration (BIOS = BIOS Management)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
250