Reference Guide

VFL0012
Message vFlash media is not enabled.
Detailed
Description
The vFlash media is not enabled.
Recommended
Response
Action
Enable the vFlash media by running the command racadm set
idrac.vFlashSD.Enable 1.
Category System Health (VFL = vFlash Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
VFL0013
Message The vFlash SD Card is in read-only mode.
Detailed
Description
The request could not be successfully completd, because the vFlash SD Card is in
read-only mode. Write operations cannot be performed on the card.
Recommended
Response
Action
Change the access mode on the vFlash SD Card to read-write.
Category System Health (VFL = vFlash Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
VFL0014
Message The vFlash SD card is not initialized.
Detailed
Description
The vFlash SD card is not initialized. Either the card is not properly formatted or it
may not be supported.
Recommended
Response
Action
Format the vFlash SD card by running the command "racadm vflashsd initialize".
Make sure that the card is supported by contacting your service provider for a list
of supported SD card types.
Category System Health (VFL = vFlash Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
2335