Reference Guide

Detailed
Description
Unable to perform iSCSI boot on the connection identified in the message because
the iSCSI login operation did not complete successfully.
Recommended
Response
Action
Do the following: 1) Go to System Setup > Network Settings > iSCSI Device Settings
> Connection Settings page, make sure the target name is correct. 2) On the iSCSI
target system, make sure the initiator name is added into the target identifiers. 3)
Compare the authentication settings in the iSCSI initiator setup page to that of the
iSCSI target system and make sure the settings match. 4) Retry the operation.
Category Configuration (UEFI = UEFI Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
UEFI0275
Message Unable to perform iSCSI boot on connection arg1 because the TCP connection
timed out when connecting to the iSCSI target.
Arguments arg1 = number
Detailed
Description
Unable to perform iSCSI boot on the connection identified in the message because
the TCP connection timed out when connecting to the iSCSI target.
Recommended
Response
Action
Do the following: 1) Make sure the iSCSI target system is online with the firewall
configured to allow TCP access. 2) Make sure the server network infrastructure is
configured to allow access to the iSCSI target. 3) Go to System Setup > Network
Settings > iSCSI Device Settings > Connection Settings page, make sure the iSCSI
initiator settings (iSCSI, DHCP, VLAN, initiator/target IP addresses) are configured
correctly. 4) Retry the operation.
Category Configuration (UEFI = UEFI Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
UEFI0276
Message Unable to perform iSCSI boot on connection arg1 because the initiator information
from DHCPv6 server cannot be obtained.
Arguments arg1 = number
Detailed
Description
Unable to perform iSCSI boot on the connection identified in the message because
the initiator information from DHCPv6 server cannot be obtained.
Recommended
Response
Action
Do one of the following: 1) Check the configuration of DHCPv6 server. 2) Go to
System Setup > Network Settings > iSCSI Device Settings > Connection Settings
page, disable DHCP and configure the initiator information manually. Retry the
operation.
Category Configuration (UEFI = UEFI Event)
2228