Reference Guide

SYS096
Message Unable to complete the diagnostics operation because the required Dell
Diagnostics firmware package is not installed.
Detailed
Description
The required Dell Diagnostics firmware package is not installed or cannot be found
in the iDRAC internal storage.
Recommended
Response
Action
Install the Dell 64bit uEFI Diagnostics firmware package, and then retry the
operation. The Dell Diagnostics can be installed using the Dell 64bit uEFI
Diagnostics Dell Update Package (DUP).
Category System Health (SYS = System Info)
Severity Severity 2 (Warning)
No alerts are applicable for this message
SYS097
Message The state of Lifecycle Controller is disabled by the configuration XML import
operation.
Detailed
Description
The Lifecycle Controller State has been set to disabled by the configuration XML
import operation. Further changes to the system configuration require the
Lifecycle Controller State to be enabled before the changes are processed.
Recommended
Response
Action
If further configuration changes are required for the system, the Lifecycle
Controller State must be enabled prior to attempting the configuration change. To
enable the Lifecycle Controller State, run the racadm command "racadm set
LifecycleController.LCAttributes.LifecycleControllerState Enabled".
Category Configuration (SYS = System Info)
Severity Severity 3 (Informational)
No alerts are applicable for this message
SYS098
Message A Remote Diagnostic (ePSA) job already exists.
Detailed
Description
A Remote Diagnostic (ePSA) job already exists and only one job of this type can
exist at a time.
Recommended
Response
Action
A response action is not required if the scheduled start time of the existing Remote
Diagnostic (ePSA) job is ok. Else, delete the existing Diagnostics (ePSA) job and
recreate another with an appropriate start time.
Category System Health (SYS = System Info)
Severity Severity 3 (Informational)
No alerts are applicable for this message
1988