Reference Guide

Detailed
Description
The Quick Deploy of Profile process has started for the server identified in the
message.
Recommended
Response
Action
No response action is required
Category Configuration (SWC = Software Config)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔* ✔*
SWC8608
Message Server Profiles: unable to access server: arg1 for operation [ arg2 ] because of one
or more of the following reasons: 1) iDRAC is not ready. 2) Lifecycle Controller of
the server is disabled.
Arguments arg1 = slot number, arg2 = wsman operation
Detailed
Description
The CMC was unable to perform the operation described in the message because
of one or more of the following reasons: 1) iDRAC is not ready. 2) Lifecycle
Controller of the server is disabled.
Recommended
Response
Action
Make sure that iDRAC on the server identified in the message is operating and that
Lifecycle Controller is enabled, and then retry the operation. If the issue persists,
perform a virtual reseat of the server and retry the operation. To perform a virtual
reseat of the server, on CMC Web interface, select Chassis Overview ->
Troubleshooting -> Reset Components. On the Reset Components page, select
Virtual Reseat from the drop-down menu for the server identified in the message.
Category Configuration (SWC = Software Config)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC ✔
1906