Reference Guide

SWC8508
Message Unable to capture Profile from server in slot arg1
Arguments arg1 = slot number
Detailed
Description
Unable to communicate with iDRAC.
Recommended
Response
Action
Check if iDRAC is ready and system is running properly. Utilize the RACADM
command by running "racadm getversion" to list all the servers and make sure the
iDRAC version is displayed. If the iDRAC is listed as Not Ready then wait until it
becomes ready. A Virtual Reseat may be required.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC ✔* ✔*
SWC8509
Message Unable to apply arg1 Profile to server in slot arg2
Arguments arg1 = profile name, arg2 = slot number
Detailed
Description
Unable to communicate with iDRAC.
Recommended
Response
Action
Check if iDRAC is ready and system is running properly. Utilize the RACADM
command by running "racadm getversion" to list all the servers and make sure the
iDRAC version is displayed. If the iDRAC is listed as Not Ready then wait until it
becomes ready. A Virtual Reseat may be required. The Lifecycle log in the server
identified in the message may have additional information about the inability of the
iDRAC to apply Profile settings.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
1882