Reference Guide

SWC0132
Message Unable to send test trap. Please make sure that your trap\nhas been configured
correctly and connectivity to \nthe destination endpoint exists.
Detailed
Description
Either the destination Ip address is not reachable or the required values are not
configured.
Recommended
Response
Action
Check for the connectivity to the configured Ip address.
Category Configuration (SWC = Software Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
SWC0133
Message Either connect or disconnect must be specified.
Detailed
Description
Insufficient information provided.
Recommended
Response
Action
Specify either the connect or the disconnect option with the subcommand.
Category Configuration (SWC = Software Config)
Severity Severity 3 (Informational)
No alerts are applicable for this message
SWC0134
Message The RAC log was cleared successfully
Detailed
Description
Success message.
Recommended
Response
Action
No response action is required.
Category Configuration (SWC = Software Config)
Severity Severity 3 (Informational)
No alerts are applicable for this message
1802