Reference Guide

SWC Event Messages
SW0725
Message iDRAC7 communication failure.
Detailed
Description
iDRAC7 is busy and does not respond to iDRAC7 configuratorIPMI requests.
Recommended
Response
Action
Try AC power cycling the server or upgrade the iDRAC firmware.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
No alerts are applicable for this message
SWC0001
Message Unable to save the network settings.
Detailed
Description
The network cable may not be connected or an internal error occurred. For more
information about the failure, see Lifecycle Log.
Recommended
Response
Action
Verify the network cable is connected and retry the operation. If the problem
persists: 1) Turn off the system and disconnect the power cord. 2) Wait for five
seconds. 3) Reconnect the power cord, turn on the system, and retry the
operation.
Category Configuration (SWC = Software Config)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
SWC0002
Message Unable to set Part Replacement policies.
1753