Reference Guide

STOR307
Message Unable to perform the configuration operation because the export log operation is
currently in progress.
Detailed
Description
Unable to perform the configuration operation because the export log operation is
currently in progress.
Recommended
Response
Action
Wait until the current export operation is complete, and then try the configuration
operation again.
Category Storage (STOR = Storage)
Severity Severity 2 (Warning)
No alerts are applicable for this message
STOR308
Message Controller is in HBA mode, RaidAction CreateAuto value is not supported.
Detailed
Description
The Controller is in HBA mode, RaidAction CreateAuto value is not supported.
Recommended
Response
Action
In order to perform a RAID configuration operation, change the controller mode to
RAID and retry the operation. For switching to RAID mode using the F2 System
Setup utility, go to Device Settings > "RAID Controller "> Controller Management >
Advanced Controller Management > Switch to RAID mode.
Category Storage (STOR = Storage)
Severity Severity 2 (Warning)
No alerts are applicable for this message
STOR309
Message Unable to run the command because multiple targets must not be entered as input
in the Blink/UnBlink Target method.
Detailed
Description
The command cannot be run because multiple targets must not be entered as
input in the Blink/Unblink Target method.
Recommended
Response
Action
Enter only one target FQDD (Fully Qualified Device Descriptor), and then retry the
operation.
Category Storage (STOR = Storage)
Severity Severity 3 (Informational)
No alerts are applicable for this message
1704