Reference Guide

No alerts are applicable for this message
RAC914
Message Value specified is invalid: Must be 0 (Off) or 1 (On).
Detailed
Description
The specified value is not within the valid range. To set the LED state to off, enter 0.
To set the LED state to on, enter 1.
Recommended
Response
Action
Set the numeric value to 0 (Off) or 1 (On).
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC915
Message Unable to change auto-negotiation property for the NIC.
Detailed
Description
The auto-negotiation property for the iDRAC NIC can be changed only if the NIC is
in dedicated mode. To change the NIC mode to dedicated, an iDRAC Enterprise
license is required.
Recommended
Response
Action
Change the NIC mode to dedicated mode by using "racadm set idrac.nic.selection
<1 | Dedicated>", and retry the operation.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC916
Message Value given exceeds the maximum threshold value.
Detailed
Description
The value given is greater than the maximum threshold value.
Recommended
Response
Action
Set values lesser than the maximum threshold value. To view the maximum
threshold value, run racadm get System.Power. Cap.MaxThreshold at the
command prompt.
Category Configuration (RAC = RAC Event)
Severity Severity 3 (Informational)
No alerts are applicable for this message
1443