Reference Guide

RAC1155
Message Unable to complete the operation because Lifecycle Controller is disabled.
Detailed
Description
The operation was not completed because Lifecycle Controller is disabled.
Recommended
Response
Action
Enable the Lifecycle Controller and retry the operation. To enable Lifecycle
Controller, run the command racadm set
LifeCycleController.LCAttributes.LifecycleControllerState 1.
Category Configuration (RAC = RAC Event)
Severity Severity 3 (Informational)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC
RAC1156
Message Unable to display the information about the server network interfaces.
Detailed
Description
The server network interface information cannot be received because the iDRAC
Service Module is not installed or not runing on the server operating system (OS) or
collection of the OS data is disabled.
Recommended
Response
Action
Run the command racadm get iDRAC.ServiceModule to check if iDRAC Service
Module is installed and running on the server operation system, and the collection
of the OS data is enabled.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
1426