Reference Guide

Detailed
Description
The minimum non critical threshold value identified in the message cannot be set,
because the value entered is lesser than, or equal to the minimum critical threshold
value.
Recommended
Response
Action
Check the minimum critical threshold level using an appropriate RACADM
command. For example, to view the minimum threshold value of a sensor, run the
racadm getsensorinfo command at the command line interface, and then retry the
operation. For more information about other RACADM commands, run the racadm
help command.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC
RAC1068
Message Unable to set minimum non critical threshold value of arg1 , because the value
entered is greater than, or equal to the maximum non critical threshold value.
Arguments arg1 = System Board Inlet Temp
Detailed
Description
The minimum non critical threshold value identified in the message cannot be set,
because the value entered is greater than, or equal to the maximum non critical
threshold value.
Recommended
Response
Action
Check the maximum non critical threshold level using an appropriate RACADM
command. For example, to view the maximum non critical threshold value of a
sensor, run the racadm getsensorinfo command at the command line interface,
and then retry the operation. For more information about other RACADM
commands, run the racadm help command.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔
CMC
1400