Reference Guide

Detailed
Description
The Prepare to Remove operation will stop any activity on the PCIe SSD device so
that it can be removed safely. The device is safe to remove when the disk shows
the safe to remove LED pattern.
Recommended
Response
Action
Press OK to continue.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC0741
Message Unable to perform Prepare to Remove or Secure Erase operations on the selected
PCIe SSD disk drive(s), because Lifecycle Controller is not enabled.
Detailed
Description
Unable to perform Prepare to Remove or Secure Erase operations on the selected
PCIe SSD disk drive(s), because Lifecycle Controller is not enabled.Retry the
operation after the server has restarted.
Recommended
Response
Action
To enable Lifecycle Controller, reboot the server. During server startup, press F2 to
enter System Setup. Go to iDRAC Settings -> Lifecycle Controller, select Enable,
and save the changes. Retry the operation after the server has restarted.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
RAC0742
Message The Secure Erase command will be executed on the selected PCIe SSD disk
drives(s) only after the reboot of the system or loss of power to the disk drives(s).
Detailed
Description
A Secure Erase operation on a PCIe SSD overwrites all blocks in an encrypted way
and all the data on the PCIe SSD device will be permanently lost. The changes will
happen after reboot of the system or loss of power to the drive.
Recommended
Response
Action
Press OK to continue.
Category Configuration (RAC = RAC Event)
Severity Severity 2 (Warning)
No alerts are applicable for this message
1351