Reference Guide

Recommended
Response
Action
Verify the Embedded System Management (ESM) Log for any sensor related faults.
If there is a failed sensor, replace the system board. For more information, contact
your service provider. Otherwise, change the warning threshold for the current
sensor such that it corresponds to the hardware configuration.
Category System Health (AMP = Amperage)
Severity Severity 2 (Warning)
OMSA Event ID 5203
OMSA Trap ID 5203
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔* ✔ ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔*
CMC
AMP404
Message The arg1 sensor detected an error with a value of arg2 A.
Arguments arg1 = sensor name, arg2 = current
Detailed
Description
The current sensor identified in the message is faulty or the current drawn by the
system exceed the critical threshold. This condition can cause system performance
issues and degradation in the moitoring capability of the system.
Recommended
Response
Action
Review system power policy, check system logs for power related failures, and
review system configuration changes. For more information, contact your service
provider.
Category System Health (AMP = Amperage)
Severity Severity 2 (Warning)
OMSA Event ID 5204
OMSA Trap ID 5204
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔* ✔ ✔
CMC
131