Reference Guide

PWR8671
Message The Chassis Management Controller is unable to set the Enhanced Cooling Mode
because the requested power arg1 AC Watts exceeds the subsystem power limit
arg2 AC Watts for IO Modules, Blowers and Servers.
Arguments arg1 = requested power level, arg2 = power limit
Detailed
Description
The Enhanced Cooling Mode feature cannot be enabled because the requested
power exceeds the Chassis subsystem power limit for IO Modules, Blowers and
Servers.
Recommended
Response
Action
Make sure the system operates within the subsystem Connector Limit for the
components specified. To review power budget information select Chassis
Overview -> Power -> Budget Status. Turn off unused components within the
subsystem to make power available to set Enhanced Cooling Mode.
Category Audit (PWR = Power Usage)
Severity Severity 3 (Informational)
Trap/EventID 8419
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔* ✔* ✔* ✔*
CMC ✔ ✔ ✔ ✔
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔*
CMC ✔* ✔*
PWR8672
Message The server in slot arg1 does not have a arg2 mezzanine card in slot arg3 .
Arguments arg1 = server slot number, arg2 = card type, arg3 = mezzanine position number
Detailed
Description
The server identified in the message does not have a card in the Mezzanine slot as
identified in the message. A mezzanine card position is identified with the following
numbers: For quarter-width server, the position number is 1. For half-width server
mezzanine C & B maps to position numbers 1 & 2 respectively. For full-width
server, mezzanine C & B on the upper- or left part of the server maps to position
numbers 1 & 2 respectively. Mezzanine C & B on the lower- or right part of the
server maps to position numbers 3 & 4 respectively.
Recommended
Response
Action
Insert a mezzanine card in the slot identified in the message.
1214