Reference Guide

Recommended
Response
Action
Increase the Power Cap value. To increase the Power Cap do one of the following:
1) Using CMC Web interface: Select "Chassis Overview" -> Power -> Configuration
and then adjust System Input Power Cap values. 2) Run the following RACADM
command at the command line interface: "config -g cfgChassisPower -o
cfgChassisPowerCap <value>". Try setting the power cap above the lower bound
displayed on the power configuration page.
Category System Health (PWR = Power Usage)
Severity Severity 2 (Warning)
Trap/EventID 2274
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔* ✔* ✔* ✔*
CMC ✔ ✔* ✔* ✔*
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔*
CMC ✔* ✔*
PWR8558
Message The System Input Power Cap is being enforced with the current Power Supply
configuration.
Detailed
Description
A configuration change has occurred such that the current power cap is now
supported.
Recommended
Response
Action
No response action is required.
Category System Health (PWR = Power Usage)
Severity Severity 3 (Informational)
Trap/EventID 2275
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔* ✔* ✔* ✔*
CMC ✔ ✔* ✔* ✔*
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔*
CMC ✔* ✔*
1183