Reference Guide

Recommended
Response
Action
Retry the operation. If the issue persists, reset the iDRAC by pressing the System ID
button for 15 seconds, wait for the iDRAC to finish restarting, and then retry the
operation.
Category Configuration
Subcategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
JCP032
Message Unable to create a job because conflicting options are entered.
Detailed
Description
The configuration job cannot be created because the -r and --realtime options
cannot be used at the same time.
Recommended
Response
Action
Make sure that only one of either -r or --realtime option is entered. For example, to
run a job immediately, enter the --realtime option. To schedule a job that will be
run after restarting a server, use the -r option. For more information about options,
see the RACADM Command Line Reference Guide available at the support site. If
the issue persists, contact your service provider.
Category Configuration
Subcategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
625