Reference Guide

Server
Administrator
Trap ID
Not Applicable
JCP024
Message Lifecycle Controller is in use. This job starts when Lifecycle Controller is available.
Detailed
Description
Lifecycle Controller cannot gain access to internal storage due to use by another
application or operation. This job starts when Lifecycle Controller is available.
Recommended
Response
Action
Wait for current Lifecycle Controller operation to complete. Verify that the system
is: 1) Not currently in Lifecycle Controller Unified Server Configurator 2) Not
waiting for user intervention at F1/F2 POST error 3) Not in any of the device or
controller Option ROMs.
Category Configuration
Subcategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
JCP025
Message Lifecycle Controller is not enabled.
Detailed
Description
Lifecycle Controller must be enabled to perform the requested operation. Lifecycle
Controller can be enabled in the F2 Setup application or through a remote
operation.
Recommended
Response
Action
If Lifecycle Controller is in Recovery mode a firmware update of Lifecycle
Controller may be required. To change the Lifecycle Controller mode, do the
following: 1) Restart the system and press F2 to launch the System Setup
application 2) Select iDRAC Configuration 3) Select Lifecycle Controller Settings to
enable Lifecycle Controller.
Category Configuration
Subcategory JCP = Job Control
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
621