Reference Guide

Server
Administrator
Trap ID
Not Applicable
ISM0005
Message The iDRAC Service Module has successfully restarted communication with iDRAC.
Detailed
Description
The iDRAC Service Module has successfully restarted communication with iDRAC.
Recommended
Response
Action
No response action is required.
Category Audit
Subcategory ISM = iDRAC Service Module
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
ISM0006
Message The iDRAC Service Module is unable to communicate with iDRAC using the OS to
iDRAC Pass-through channel.
Detailed
Description
The iDRAC Service Module could not successfully communicate with iDRAC,
because the OS to iDRAC Pass-through channel is not configured in the USB-NIC
mode.
Recommended
Response
Action
Make sure that the OS to iDRAC Pass-through channel is configured only in the
USB-NIC mode, and then retry the operation. To enable the OS-to-iDRAC Pass-
through channel, run the following command in the order they are listed: 1)
racadm set idrac.os-bmc.PTMode usb-p2p 2) racadm set idrac.os-
bmc.UsbNicIpAddress <ip address> 3) racadm set idrac.os-bmc.adminstate
enabled
Category Audit
Subcategory ISM = iDRAC Service Module
Severity Severity 1 (Critical)
602