Reference Guide

Server
Administrator
Trap ID
Not Applicable
DIAG0154
Message Tape Drive arg1 - S/N arg2 , incorrect status = arg3 \n arg4 .
Arguments
• arg1 = Drive Location
• arg2 = Serial Number
• arg3 = 80000000000000??
• arg4 = Error Reason
Detailed
Description
Recommended
Response
Action
Check installation of the tape drive, cables and connections. If the error persists,
ensure that drive firmware is current.
Category Storage
Subcategory DIAG = Diagnostic
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
DIAG0155
Message Hard Drive - Not installed.
Detailed
Description
Recommended
Response
Action
Power down system and check the signal and power connections to the hard
drive. Rerun the diagnostic.If no error occurs then it was a cable or connector
issue. This error is issued for notebooks which must have a hard disk so it is an
error if not found.
Category Storage
Subcategory DIAG = Diagnostic
367