Reference Guide

Detailed
Description
Unable to load one or more option ROMs because of insufficient base memory.
The base memory is memory below 640K.
Recommended
Response
Action
Do one of the following: 1) Remove unused PCIe card(s) to free up option ROM
space. 2) Disable unused boot protocol instances (such as PXE, iSCSI, etc.) from
applicable PCIe card(s) option ROM configurations. 3) If possible, install and run the
Operating System in UEFI boot mode.
Category Configuration
Subcategory UEFI = UEFI Event
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default LC Log
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
UEFI0133
Message Unable to perform PXE boot because the VLAN settings conflict with that of the
iSCSI device settings.
Detailed
Description
Unable to perform PXE boot because the VLAN settings conflict with that of the
iSCSI device settings.
Recommended
Response
Action
Do one of the following: 1) Go to System Setup and change the VLAN
configuration for the PXE device to match that of the iSCSI device. Either both
devices must be configured with VLAN enabled or both devices must be
configured with VLAN disabled. 2) Change the PXE device interface setting to use a
different NIC interface than the NIC interface used by the iSCSI device.
Category Configuration
Subcategory UEFI = UEFI Event
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default LC Log
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
2087