Reference Guide

UEFI0015
Message Lifecycle Controller (LC) firmware was not accessible and is therefore in Recovery
mode.
Detailed
Description
The BIOS is unable to access the Lifecycle Controller firmware. No Lifecycle
Controller functionality is available while in Recovery Mode.
Recommended
Response
Action
Perform the following actions: 1)Reboot the system. 2) Press F2 during boot to
enter System Setup. 3) Select iDRAC Settings then Lifecycle Controller. 4) Change
Lifecycle Controller back to Enabled. If subsequent failures occur, press and hold
the system ID button down for 15 seconds to reset the iDRAC. For more
information on how to reset iDRAC, see iDRAC Users Guide.
Category System Health
Subcategory UEFI = UEFI Event
Severity Severity 1 (Critical)
LCD Message No LCD message display defined.
Initial Default LC Log
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
UEFI0016
Message Lifecycle Controller (LC) firmware was not accessible and is therefore in Recovery
mode.
Detailed
Description
Unable to find a Lifecycle Controller partition. No Lifecycle Controller functionality
is available while in Recovery Mode.
Recommended
Response
Action
Perform the following actions: 1)Reboot the system. 2) Press F2 during boot to
enter System Setup. 3) Select iDRAC Settings then Lifecycle Controller. 4) Change
Lifecycle Controller back to Enabled. If subsequent failures occur, press and hold
the system ID button down for 15 seconds to reset the iDRAC. For more
information on how to reset iDRAC, see iDRAC Users Guide.
Category System Health
Subcategory UEFI = UEFI Event
Severity Severity 1 (Critical)
LCD Message No LCD message display defined.
Initial Default LC Log
2023