Reference Guide

Server
Administrator
Trap ID
Not Applicable
TMP0302
Message Unable to set Enhanced Cooling Mode because the required power or fan
configuration is not available.
Detailed
Description
The Enhanced Colling Mode feature cannot be enabled because the necessary
power or fan configuration is not available.
Recommended
Response
Action
Do the following: 1) Check the available power and the fan configuration. 2) If the
required power for Enahnced Cooling mode is not available, remove other chassis
components which are not being used in order to obtain sufficient power. 3) If the
fan configuration does not support Enhanced Cooling Mode, replace unsupported
fans with supported ones. 4) If the issue persists, contact your service provider.
Category System Health
Subcategory TMP = Temperature
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
TMP1000
Message arg1 exceeded the maximum warning threshold.
Arguments
• arg1 = tempsensor name
Detailed
Description
The enclosure is too hot. A variety of factors can cause the excessive temperature.
For example, a fan may have failed, the thermostat may be set too high, or the
room temperature may be too hot.
Recommended
Response
Action
Check for factors that may cause overheating. For example, verify that the
enclosure fan is working. You should check the thermostat settings and examine
whether the enclosure is located near a heat source. Make sure the enclosure has
enough ventilation and that the room temperature is not too hot. Refer to the
enclosure documentation for more diagnostic information.
Category Storage
1997