Reference Guide

LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
STOR074
Message The requested RAID configuration operation is not allowed because the controller
is currently in Non-RAID mode.
Detailed
Description
The requested RAID configuration operation will not be allowed because the RAID
controller is currently in Non-RAID mode.
Recommended
Response
Action
In order to perform a RAID configuration operation, change the controller mode to
RAID and retry the operation. For switching to RAID mode using the F2 System
Setup utility, go to Device Settings > "RAID Controller "> Controller Management >
Advanced Controller Management > Switch to RAID mode.
Category Configuration
Subcategory STOR = Storage
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
STOR075
Message The operation cannot be performed because the enclosure configuration mode
(Split or Unified) change request is pending.
Detailed
Description
The requested operation could not be completed because there is an operation
pending to change the enclosure configuration mode (Split or Unified). This
operation is exclusive because it involves changing the RAID backplane topology.
Recommended
Response
Action
Do one of the following: 1) Create a job to complete the pending enclosure mode
change request operation, allow the job to complete, restart the server, and then
1631