Reference Guide

Server
Administrator
Trap ID
Not Applicable
RAC1070
Message Unable to set the maximum non critical threshold value of arg1 , because the value
entered is greater than, or equal to the maximum critical threshold value.
Arguments
• arg1 = System Board Inlet Temp
Detailed
Description
The maximum non critical threshold value identified in the message cannot be set,
because the value entered is greater than or equal to the maximum critical
threshold value.
Recommended
Response
Action
Check the maximum critical threshold level using an appropriate RACADM
command. For example, to view the maximum critical threshold value of a sensor,
run the racadm getsensorinfo command at the command line interface, and then
retry the operation. For more information about other RACADM commands, run
the racadm help command.
Category Configuration
Subcategory RAC = RAC Event
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
RAC1071
Message Unable to set maximum non critical threshold value of arg1 , because the value
entered is less than, or equal to the minimum non critical threshold value.
Arguments
• arg1 = System Board Inlet Temp
Detailed
Description
The maximum non critical threshold value identified in the message cannot be set,
because the value entered is less than or equal to the minimum non critical
threshold value.
1349