Reference Guide

Recommended
Response
Action
To enable the CSIOR feature, run the RACADM command "racadm set
LifecycleController.LCAttributes.CollectSystemInventoryOnRestart 1". Then restart
the server to cause system inventory information to be collected.
Category Configuration
Subcategory RAC = RAC Event
Severity Severity 2 (Warning)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
RAC1061
Message SystemErase operation initiated successfully.
Detailed
Description
The requested SystemErase operation was initiated successfully.
Recommended
Response
Action
Check the job status by running the RACADM command: "racadm jobqueue view -i
<JobID>".
Category Configuration
Subcategory RAC = RAC Event
Severity Severity 3 (Informational)
LCD Message No LCD message display defined.
Initial Default None
Server
Administrator
Event ID
Not Applicable
Server
Administrator
Trap ID
Not Applicable
RAC1062
Message Unable to initiate the SystemErase operation. The component identifier specified is
not valid.
1344