Reference Guide

RAC961
Message A pending or committed system configuration change exists.
Detailed
Description
Another import operation cannot be started if an import operation that was performed earlier
has some pending or commited configuration changes.
Recommended
Response Action
Wait until the configuration changes are applied before starting another import operation. Use
the ?racadm jobqueue view? command to check the status of the current import operation.
Category Configuration
SubCategory RAC = RAC Event
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
RAC962
Message Unable to continue with the operation because Lifecycle Controller is in recovery state,
Detailed
Description
Lifecycle Controller must be enabled to run the operation.
Recommended
Response Action
Enable the Lifecycle controller using the ?racadm set
LifeCycleController.LCAttributes.LifecycleControllerState 1? command, and retry the operation.
Category Configuration
SubCategory RAC = RAC Event
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
RAC963
Message Unable to retrieve the status of Lifecycle Controller.
906